Coltene SciCan BRAVO G4 Manuel D'utilisation page 42

8.6 USER-DEFINED CYCLE
The Custom Cycle is intended for sterilization of medical devices that have specific reprocessing requirements that
cannot be met by the unit's existing validated sterilization cycles.
To use a Custom Cycle follow the device manufacturer's IFU concerning the selection of sterilization monitoring and
packaging accessories.
1.
To set parameters, select the following button:
2.
HOLD down the following button to access
settings:
3.
Select the type of pre-vacuum (fractionated or
single), the process temperature, the exposure time
and total drying time.
Refer to the device manufacturer's Instructions for Use (IFU) to
determine the required sterilization process temperature and
exposure time.
4.
Once you have made the selections, press the
ENTER button to save the settings and go back to
the previous screen.
Press START button to start the user-defined cycle.
38