Housing Serial Port Menu; Polarity Menu; Block Camera Menu - Videotec ULISSE Manuel D'instructions

9.6.4 Housing Serial Port Menu

j Once you have exited from the camera
OSM, press the IRIS CLOSE key to return to
the Pan & Tilt OSM.
j To prevent the camera OSM from
overlapping the Pan & Tilt OSM, exit from
the camera configuration mode before
pressing the IRIS CLOSE key.
01. Protocol: Allows the setting of the protocol
used for the serial communication with the
camera.
02. Baud Rate: Allows the setting of the baud rate
used for the serial communication with the
camera.
03. Return Cmd: Allows the personalization of
the Confirm command ("9.1.1 How to use the
joystick", page 25) for navigating inside the
camera OSM.
04. Exit Cmd: Allows the personalization of the
Exit command ("9.1.1 How to use the joystick",
page 25) for navigating inside the camera
OSM.
05. Enable Camera OSM: Allows access to the
camera configuration mode.
HOUSING SERIAL PORT
------------------------
1>PROTOCOL
2 BAUDRATE
3 RETURN CMD: IRIS CLOSE
4 EXIT CMD
5 ENABLE CAMERA OSM
Fig. 66
: NONE
: 9600
: IRIS OPEN
>

9.6.5 Polarity Menu

The following parameters can be set from the Polarity
menu:
01. Zoom: Allows the setting of the rotation polarity
of the lens Zoom motor.
02. Focus: Allows the setting of the rotation polarity
of the lens Focus motor.
03. Iris: Allows the setting of the rotation polarity of
the lens Iris motor.
POLARITY
------------------------
1>ZOOM :
2 FOCUS:
3 IRIS :
Fig. 67

9.6.6 Block Camera menu

01. Area titling: Allows access to the area titling
submenu.
02. Enabling: Enables masking of the relative zone.
03. Masking: Allows access to the dynamic masking
submenu.
04. Advanced: Allows access to the advanced
settings submenu of the SONY module.
BLOCK CAMERA
------------------------
1>ZONE TITLING
2 MASKING
3 ADVANCED
Fig. 68
POSITIVE
POSITIVE
POSITIVE
>
>
>
31