Adjusting The Power Supply Voltage Of The Lens Motors; Installation; Connecting The Cables To The Base - Videotec ULISSE Manuel D'instructions

7.1.2.3 Adjusting the power supply voltage
of the lens motors
Before powering the Pan & Tilt, set the lens power
voltage using DIP1.
Fig. 19
LENS POWER SUPPY VOLTAGE
DIP 1 DIP 2
OFF OFF
ON OFF
OFF ON
ON ON
Tab. 03
16
DIP1
Configuration
15Vdc
12Vdc
9Vdc
6Vdc

7.2 Installation

7.2.1 Connecting the cables to the base

h Do not make any changes or install
connections that are not included in this
handbook. Failure to follow the connection
instructions that are given in the handbook
may create serious safety hazards for
people and for the installation.
h Do not change the wiring in the product
as it is supplied to you. Failure to follow
this instruction may create serious safety
hazards for people and for the installation,
and will also invalidate the guarantee.
j If using the washer kit (UPTWAS), the
spray support should be installed before
positioning the pan & tilt and the wiring.
For further explanations see the specific
handbook for the kit.
Fig. 20
j Keep a connection diagram for future
reference.