Zone Titling Menu - Videotec ULISSE Manuel D'instructions

9.6.6.1 Zone titling menu

Once inside the Edit Zone menu it is possible to set
the following parameters.
01. Number: Selects the area to be edited.
02.
03. Start: Sets the initial position of the area.
04. Stop: sets the final position of the area.
05. Text: Modifies the text which is displayed when
moving within the zone.
EDIT ZONE
------------------------
1>NR :
2 ENAB.:
3 START:+
4 STOP :+
5 TEXT :TXT ZONE1
Fig. 69
32
1
N
0.00
0.00
Example: To enable titling of zone 1 when the device
is between +15° and +45°, it is necessary to:
01. Enable area titling by setting Y as the value of
Enabling under the Area Titling menu.
02. Set 1 as the value of parameter Nr under the
Edit Area menu.
03. Set +15.00 as the value of parameter Start
under the Edit Zone menu.
04. Set +45.00 as the value of parameter Stop
under the Edit Zone menu.
05. If necessary, edit the displayed text by selecting
Text under the Edit Zone menu.
j Setting the Start and Stop values of the Edit
Zone menu to zero will disable text display.
If there are overlapping areas, the area with
the highest number will prevail.
j To define zones proceed in a clockwise
direction, as shown in the figure.
Stop2=225°
270°
180°
Start2=170°
Fig. 70
The default name and position of the
j
zones of the pan & tilt refer to the four
cardinal points. The NORTH position can
be modified by means of the Offset Pan
parameter in the movement menu ("9.6.7
Movement menu", page 38).
Start1=15°
0°
Stop1=45°
90°