8.1 Before powering the device
The first time the device is switched on we
recommend making sure it is configured correctly.
To do this, disconnect the power supply, remove the
dip-switch protection window and set the firmware
update dip-switch rocker to ON.
Power the device and after a few seconds it will be
possible to check the settings on the screen.
After completing the check, switch off the device
and re-toggle the firmware update dip-switch rocker
to the down position (number 1 in the baud rate
section).
Close the window and re-connect the power supply.
8.2 Checks list
While it is switching on, the device displays a list of
the checks it has to carry out before starting normal
operation.
STARTUP
------------------------
TEST FLASH
HOMING PROCEDURE
ZFI SEARCH
IO EXPANDER
IR360 STATE
Fig. 45
If one of the checks fails (ERR), seek
h
assistance. The message Off means that the
pan & tilt is not fitted with the described
option.
9 Configuration
9.1 On Screen Menu (OSM)
During normal ULISSE operation it is possible to
activate the On Screen Menu in order to set the
advanced functions using the corresponding key/s
(see the handbook for the keyboard you are using).
Exit the On Screen Menu with Zoom Wide (or
Zoom-).
9.1.1 How to use the joystick
All operations in the menus are carried out using the
joystick.
: OK
: OK
: OK
:OFF
Fig. 46
:OFF
Fig. 47
j
Up
Left
Down
Pan & tilt.
Exit
Zoom wide & tele.
If using a control keyboard with a dual axis
joystick, use the Zoom Wide and Zoom
Tele keys to carry out the Exit and Confirm
commands.
Right
Confirm
25