How To Move Around The Menus; Manual Control; How To Change The Settings - Videotec ULISSE Manuel D'instructions

9.2 How to move around the
menus
Each page of the OSM shows a list of parameters or
sub-menus that can be selected by the operator. To
scroll through the parameters move the cursor by
operating the joystick (up and down).

MANUAL CONTROL

------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 48
The symbol > at the end of a line indicates the
presence of a specific submenu. To enter the
submenu just confirm the menu item. To exit the
submenu use the Exit funcjtion (Zoom Out).
MANUAL CONTROL
------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 49
26
: 20.00
N
: 2
>
: 20.00
N
: 2
>

9.3 How to change the settings

Move the cursor to the parameter to be changed and
confirm. The field will start flashing, indicating that
it is in change mode. Operating the joystick (up and
down) will show the alternative choices.
MANUAL CONTROL
------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 50
After identifying the desired selection, confirm.
MANUAL CONTROL
------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 51
The parameter will stop flashing to confirm the
choice.
: 20.00
N
: 2
>
: 20.00
N
: 2
>