Advanced Setting Menu (White Balance); Advanced Setting Menu (Other); Movement Menu - Videotec ULISSE Manuel D'instructions

9.6.6.11 Advanced setting menu (White
Balance)
Once inside the White Balance menu it is possible to
set the following parameters:
01. Mode: Sets the type of control on White Balance.
The possible values are:
• Auto: Sets automatic white balance. This is
the recommended setting;
• ATW: Enables Auto Tracing White Balance;
• Indoor: Sets fixed red and blue gains for
indoor applications;
• Outdoor: Sets fixed red and blue gains for
outdoor applications;
• Manual: Enables manual setting of red and
blue gains;
• Out Auto: Sets the red and blue gain values
for outdoors;
• Lamp Auto: Sets the red and blue gain values
for sodium vapour lamps;
• Lamp Fixed: Sets the red and blue fixed gain
values for sodium vapour lamps.
02. Red Value: Sets the value of the red gain
03. Blue Value: Sets the value of the blue gain.
WHITE BALANCE
------------------------
1>MODE
2 RED VALUE :
3 BLUE VALUE:
Fig. 83
This is a dynamic self-configuration menu based on
che choice made and displays the parameters on
which it is possibile to operate.
38
: MANUAL
0
0

9.6.6.12 Advanced setting menu (Other)

01. Sharpness: Sets the sharpness value of the
image.
02. High Resolution: Enables the High Resolution
function. The output video signal has a higher
resolution.
03. Wide Dynamic: Enables the Wide Dynamic
function. It improves vision when some zones
within the frame are much brighter than others.
04. Stabilizer: Enables the electronic image
stabilization function. Recommended for
installations subject to vibrations.
05. Progressive Scan: Enables the Progressive
Scan function. Gives a more stable image when
the Pan & Tilt is connected to a video server.
06. Noise Reduction: Sets the noise reduction
level. Vary the parameter according to the
environmental conditions to obtain a higher
contrast image.
OTHER
------------------------
1 SHARPNESS
2 HIGH RESOLUTION :
3 WIDE DYNAMIC
4 STABILIZER
5 PROGRESSIVE SCAN:
6 NOISE REDUCTION :
Fig. 84
This is a dynamic self-configuration menu based on
the Pan & Tilt model.

9.6.7 Movement menu

01. Offset Pan: The pan & tilt has a mechanically
defined 0° position. The Offset Pan function
allows the definition of a different 0° position
using software.
02. Manual Control: To access the submenus
operating the parameters associated with the
manual movements of the device.
03. Preset: To access the submenus used to to edit
Preset values.
: 6
N
: OFF
: N
Y
2