About This Manual; Typographical Conventions; Notes On Copyright And Information On Trademarks; Safety Rules - Videotec ULISSE Manuel D'instructions

1 About this manual

Before installing and using this unit, please read this
manual carefully. Be sure to keep it handy for later
reference.

1.1 Typographical conventions

DANGER!
g
High level hazard.
Risk of electric shock; disconnect the
power supply before proceeding with any
operation, unless indicated otherwise.
DANGER!
l
Hot surface.
Avoid contact. Surfaces are hot and may
cause personal injury if touched.
DANGER!
i
Mechanical hazard.
Risk of crushing or shearing.
h WARNING!
Medium level hazard.
This operation is very important for the
system to function properly. Please read
the procedure described very carefully and
carry it out as instructed.
j INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
2 Notes on copyright and
information on trademarks
The quoted names of products or companies are
trademarks or registered trademarks.

3 Safety rules

h The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves
the right to modify its contents without any
prior notice. The documentation contained
in this manual has been collected with great
care, the manufacturer, however, cannot
take any liability for its use. The same thing
can be said for any person or company
involved in the creation and production of
this manual.
The integrated positioning systems for video
surveillance comprising the ULISSE line of devices
comply with current legislation and standards in force
at the time of publication of this handbook.
Nevertheless, in order to ensure the user's safety
(installer technician and operator) the following
warnings are specified in order to work in maximum
safety:
If it is necessary to transport the device,
h
this should be done with great care. Abrupt
stops, bumps and violent impact could
damage the unit or injure the user.
The building must be equipped with a
h
20A maximum bipolar protection circuit
(magneto thermal), that must include a
bipolar automatic-type circuit breaker,
which must also envisage earth fault
current protection (magneto-thermal +
differential) with minimum distance of
3mm between contacts.
• The device must be installed only and exclusively
by qualified technical personnel.
• Before any technical work on the appliance,
disconnect the power supply.
• Do not use power supply cables that seem worn
or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook: improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
7