Attachment With A Pole Support (Optional); Cables Management; Assembling And Installing; Assembly - Videotec ULISSE Manuel D'instructions

6.4.1.2 Attachment with a pole support
(optional)
The pole support allows the passage of the
connection cables. The base can be attached to the
pole in 4 distinct positions, turning through 90° to
each other, in order to facilitate positioning of the
configuration board.
Fig. 09

6.4.2 Cables management

The connection cables should not be
h
accessible from the outside; what is more,
since the cable could be pulled out it
is necessary to fasten it securely to the
pole in order to prevent excessive weight
pulling it out by accident and rendering the
apparatus unsafe.
h You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
50cm
Fig. 10
7 Assembling and
installing
h

7.1 Assembly

7.1.1 Assembling the camera and
motorised lenses (only for model
without camera module)
For some models of the P&T the customer has to take
care of assembling the camera and lenses.
h
Ø 101.6
h
7.1.1.1 Housing opening and camera
installation
To open the housing, undo the screws on the side
and swivel the upper body until it is completely open.
50cm
Fig. 11
Only specialised personnel should be
allowed to assemble and install the device.
The correct device working, in the stated
temperature range, is guaranteed with the
use of camera and lens with temperature
from -10°C up to +60°C.
The camera output video signal must be of
the composite type with amplitude 1Vpp
(negative sync).
13