Installation; Preparing The Housing - Videotec NXW Manuel D'instructions

6 Installation

6.1 Preparing the housing

Dismantle the front flange (01) of the housing by
unscrewing the four screws (02) with the hexagonal
wrench (03) provided.
Fig. 1
Position the glass in its seating on the flange, after
correctly inserting the O-rings in the order as shown.
Fig. 2
MNVCNXW_2222_EN
01
03
02
If there is an IR-proof filter glass, see the specific
assembly instructions (7.1 Installation of IR-proof
glass kit, page 9).
Position the front flange of the housing on the body,
making sure that the sealing rings are correctly
inserted in their seating so as not to damage
them. Tighten the 4 screws using the allen wrench
supplied.
Fig. 3
5