Wan Setting - Videotec ULISSE Manuel D'instructions

9.7.2.1 WAN setting

Next, set the static IP address, which is used to
gain access to the unit that is to be configured. For
example, set a static IP and address 192.168.0.101.
Fig. 107
Next, click on Apply and then click on Save &
Reboot. Wait about 30 seconds, until the settings
have been saved. Re-connect to the modified address
(e.g. 192.168.0.101), inserting the Account Name and
Password (use the default settings if they have not
been changed).
Then edit the other parameters, for example:
• Date Setting: To set date and time.
• Video Setting: To change resolution (720x576,
640x480, 352x288, 176x144) bit rate (setting
between 28kbit and 3 Mbit).
46
For telemetry, leave the default settings.
Fig. 108
After all the settings have been inserted, remember
to Save & Reboot, so that the changes will take
effect.
• Factory Default: Used to restore default factory
settings.
h In extreme cases, when you have forgotten
the password for accessing the unit via the
browser, you can also restore the factory
settings by pressing a Reset button situated
inside the base.
Fig. 109
For Reset to take effect, you have to disconnect the
power supply to the pan & tilt and then press the
reset button, and keep it pressed while reconnecting
the power supply.
Keep the button pressed for 5 seconds.and then
release it.
The factory default values of the unit are restored.
RESET button