Setting The Baud Rate; Setting The Protocol; Setting The Address; Serial Communication Lines - Videotec ULISSE Manuel D'instructions

7.4.2 Setting the baud rate

Dip-switches 4, 3 and 2 are used to set the
communication rate of the device according to the
table below.
Dip-switch number 1 is used to update the firmware.
During normal use, make sure the rocker is OFF
(DIP1=OFF).
j When the dip-switch rocker is up it
represents the value 1 (ON) while if it is
down it represents the value 0 (OFF).
BAUDRATE SETTING
Description DIP
4
Baudrate OFF OFF OFF
adjustment
ON OFF OFF
OFF ON OFF
ON
OFF OFF ON
ON OFF ON
OFF ON
ON
Firmware update -
-
Tab. 08

7.4.3 Setting the protocol

Video positioning systems with the ULISSE line can be
controlled by a range of protocols.
j When the dip-switch rocker is up it
represents the value 1 (ON) while if it is
down it represents the value 0 (OFF).
PROTOCOL SETTING
DIP DIP
8 7
MACRO OFF OFF OFF OFF OFF ON
(VIDEOTEC)
PANASONIC OFF OFF OFF ON OFF ON
PELCO D OFF OFF OFF OFF ON
AMERICAN OFF OFF OFF OFF ON
DYNAMICS
VISTA OFF OFF OFF ON
Tab. 09
22
DIP DIP DIP Configuration
3 2 1
- 300 baud
- 600 baud
- 1200 baud
ON OFF - 2400 baud
- 4800 baud
- 9600 baud
ON - 19200 baud
ON ON - 38400 baud
- - ON Set up enabled
- - OFF Set up disabled
DIP DIP DIP DIP DIP
6 5 4 3
ON
OFF OFF
OFF OFF ON
ON ON
OFF OFF ON

7.4.4 Setting the address

The ULISSE address can have a setting from 1 to 255.
Binary code is used to select the address, using the
8 dip-switches at the top right ("17 Appendix A - Dip-
switch address table", page 63).

7.4.5 Serial communication lines

The product is designed with two RS485 serial
communication lines and one RS232 serial line, which
can have various settings according to the positions
of dip-switches 10 and 9 on the Serial and Address
selector.
When the dip-switch rocker is up it
j
represents the value 1 (ON) while if it is
down it represents the value 0 (OFF).
SERIAL AND ADDRESS, SERIAL LINE CONFIGURATION
DIP DIP
10 9
OFF OFF
OFF ON
ON OFF
ON ON
Tab. 10
DIP
2 1
ON
OFF
ON
DIP Configuration
8-1
- It allows the one-way communication
on RS485-1 line ("7.4.5.1 RS485 RX line",
page 23).
- It allows the full-duplex communication
according to RS422 standard ("7.4.5.2
RS422 line (RS485-1 RX and RS485-2 TX)",
page 23).
- It allows the cascade configuration of
different devices. The signal is repeated
from every units ("7.4.5.3 RS485-1
line reception, RS485-2 line repetition",
page 23).
- It allows the two-ways, half-duplex,
communication on RS485-1 line ("7.4.5.4
RS485 TX/RX line", page 23).