Saving The Current Position (Preset); Recalling A Position (Scan); Enabling Patrol Function; Enabling Autopan Function - Videotec ULISSE Manuel D'instructions

11.2 Saving the current position
(Preset)
The current position can be saved using the control
device being used (for additional information refer to
the manual of the device being used).

11.3 Recalling a position (Scan)

Using the control device it is possible to recall
a previously saved Preset position (for further
information refer to the manual of the control device
in use).

11.4 Enabling Patrol function

The Patrol function loads the saved Presets in
sequence.
Using the control device it is possible to enable the
automatic patrol (for further information refer to
the manual of the control device in use or to Tab. 14,
page 53).
Disabling can be carried out by moving the joystick
or by recalling a different type of movement.

11.5 Enabling Autopan Function

The Autopan function loads the 2 saved Presets in a
continuous manner.
Using the control device it is possible to enable the
Autopan (for further information refer to the manual
of the control device in use or to Tab. 14, page 53.
Disabling can be carried out by moving the joystick
or by recalling a different type of movement.
52
11.6 Recalling the Home
position
Using the control device it is possible to recall the
Home position (Scan No. 1) (for further information
refer to the manual of the control device in use).

11.7 Enabling the Wiper (Wiper)

h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the Wiper refer to the manual of
the control device in use or to Tab. 14, page 53).
If it is left on, the Wiper automatically
j
disables itself.
11.8 Enabling the Washer
(Washer)
h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
Before using the washing system save a Preset with
the housing glass positioned in correspondence with
the spray.
To enable/disable the Washer refer to the manual of
the control device in use or to Tab. 14, page 53).
Wash duration can be set using in the OSM menu
("9.6.9.2 Washer Menu", page 43).

11.9 Reboot the device

By means of the control device it is possible to
send the device resetting command (for further
information refer to the manual of the control device
in use or to Tab. 14, page 53).