Ulisse For Thermal Cameras; General; Mechanical; Electrical/Video - Videotec ULISSE Manuel D'instructions

15.2 ULISSE for thermal cameras

15.2.1 General

Germanium glass window
Build in die-cast aluminium and ABS
Epoxypolyester powder painting, RAL9002 colour
Top mount (OTT)
Transmission through toothed belt
Slip-ring
Electronic limit switches
Plug installation thanks to connector and easy
replacement on-site
Zero backlash
Supplied with instruction manual

15.2.2 Mechanical

3 cable glands M16
Horizontal continuous rotation
Vertical rotation -90° to +40°
Variable pan speed: from 0.02° up to 100°/s
Variable tilt speed: from 0.02° up to 40°/s
Internal usable area: see drawings
Internal usable area with reversed slide: see drawings
Germanium glass Window
2mm (0.07in) thick, Ø 70mm (2.8in) external, Ø 55mm
(2.1in) internal
External non-scratch treatment (hard carbon coating)
Internal antireflection treatment
Spectral range from 7.5 to 14μm IR range
Average transmission from 7.5 to 11.5μm, 94%
Average transmission from 11.5 to 14μm, 90%

15.2.3 Electrical/video

Input voltage:
- 230Vac, 50/60Hz, 100W max
- 24Vac, 50/60Hz, 100W max
Absorbed current:
- 24Vac, 4A
- 120Vac, 0.8A
- 230Vac, 0.4A
Dimensions of input cables: AWG 16-19
Dimensions of signal cables: AWG 20-26
Housing standard heater 24Vac, 20W max
Camera output: 12Vdc, 800mA
Lens output: 6-15Vdc, max 200mA
Lenses control: polarity inversion and common wire
Autopan, Preset, Patrol
250 max preset selectable (VIDEOTEC Macro Protocol)
15 characters string for Area and Preset titling
Preset accuracy: 0.02°
Use only cameras with composite video output 1Vpp-
75Ohm

15.2.4 Communications

OSM configuration
RS232 interface for PC control set-up and firmware
upgrade
Two RS485 ports for daisy chain configuration
Addressable through dip-switch up 255 units

15.2.5 Protocols

AMERICAN DYNAMICS, PANASONIC, PELCO D, VIDEOTEC
MACRO, VISTA
AMERICAN DYNAMICS, PANASONIC, PELCO, VISTA are registered trademarks.
The product may be interfaced with devices not manufactured by
VIDEOTEC. It is possible that the interface protocols have changed or are in
a different configuration from earlier tested units by VIDEOTEC. VIDEOTEC
recommends a test prior to installation. VIDEOTEC will not be liable for
any installation costs or lost revenues in the event a compatibility problem
will occur.

15.2.6 Environment

Indoor / Outdoor
Operating temperature with heater. -20°C / +50°C (-4°F
/ +122°F)
Wind Resistent
- Withstand statically 150km/h (93,2mph) to wind
- Withstand dynamically and operationally with the
maximum rotating speed in 90km/h (55,9mph) wind
conditions
- Withstand dynamically and operationally with
limited rotating speed in 120km/h (74,6mph) wind
conditions
Resistant to the salt-air fog according to EN50130-5 and
EN60068-2-52

15.2.7 Compliance to

CE according to EN60950, EN61000-3-2 and EN50130-4
FCC part 15
IP66 according to EN60529
59