How To Install The Camera; 12Vdc/24Vac Version; 120/230Vac Version; Housing Closure - Videotec NTM Manuel D'instructions

6.2 How to install the camera

Assemble the camera on the slide using the
insulating spacer (01) and the 1/4" screw and the
washer (02) provided. If necessary, use the spacers to
position the camera and lens correctly.
Fig. 3
Insert the cables through the cable glands and
electrically connect.
Ensure the cable glands are firmly fastened.

6.2.1 12Vdc/24Vac version

When the power supply voltage is 24Vac the circuit
will be connected by the terminals shown.
IN 12Vdc/24Vac
OUT 12Vdc/24Vac
Fig. 4
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).
MNVCNTM_2021_EN
Heater OUT 12Vdc/24Vac

6.2.2 120/230Vac version

When the power supply voltage is 120/230Vac the
circuit will be connected by the terminals shown.
IN 120/230Vac
OUT 120/230Vac
Fig. 5
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).

6.3 Housing closure

Before closing the housing reinsert the bottom
orientating the slide according to the installation
required, on the wall bracket or on the Pan & tilt
head, for the right camera fitting (6.4 Installing the
housing, page 6).
Pay attention not to damage the gasket.
Make sure that the sealing ring is correctly fitted in
its position.
Heater OUT 120/230Vac
5