Housing Opening; How To Install The Camera; Housing Closure; Installing The Housing - Videotec NXW Manuel D'instructions

6.2 Housing opening

Unscrew the screws (01) on the rear flange (02) using
the hexagonal wrench (03) provided.
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
By doing so, you can access inside the housing
without dismantling the support bracket.
Fig. 4

6.3 How to install the camera

Open the housing as described in the relative
chapter (6.2 Housing opening, page 6).
Assemble the camera on the slide using the
insulating spacer (01) and the 1/4" screw and the
washer (02) provided. If necessary, use the spacers to
position the camera and lens correctly.
02
Fig. 5
Insert the cables through the cable glands and
electrically connect.
Ensure the cable glands are firmly fastened.
6
01
03
02
01

6.4 Housing closure

Pay attention to the fixing. Tightening
torque: 4Nm.
After installation and wiring, close the product.
Pay attention not to damage the gasket.
Make sure that the sealing ring is correctly fitted in
its position.

6.5 Installing the housing

Pay attention to the fixing. Tightening
torque: 4Nm.
Fasten the housing to the bracket using the screws
provided.
Fig. 6
MNVCNXW_2222_EN