How To Open The Housing; Fastening Of The Lens And Camera To The Internal Slide - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.1.3.1 How to open the housing

To open the housing, undo the screws on the sides
and lift the upper body.
Fig. 7
7.1.3.2 Fastening of the lens and camera to
the internal slide
It is necessary to insulate the camera
body from the attachment slide in order
to prevent interference with the Ethernet
signal.
Maximum overall weight allowed for
camera and lens must not exceed 7.6kg
(16.8lb).
Connect the camera (02) to the lens (01).
Fasten the L-shaped small aluminium bracket (03) to
the camera by means of the nylon washer (04) and
the 1/4" screw (05).
Fig. 8
Position the lens on the slide (02) interposing the
plastic spacer (01), and fasten the whole assembly by
means of the nylon washer (03)and the 1/4" screw
(04).
MNVCUPTMAXIR_1430_EN
01 02
03
04
If necessary, use the additional spacers to correctly
position the camera and lens.
02
03
04
Fig. 9
Fasten the aluminium plate (01) on the slide by
means of the M4 screws and relative washers (02).
Fig. 10
Fasten the small plates with the M4 screw (01).
Fig. 11
05
01
01
02
01
15