Mectron starlight uno Mode D'emploi Et D'entretien page 21

Power LED Battery LED
ON OFF
ON OFF
Table 3 – Description of light signals on the charging unit.
5 BATTERY
starlight uno is powered by a rechargeable lithium-ion battery already contained inside the
handpiece, with no memory effect.
starlight uno is equipped with two microprocessors that check the battery continuously and
maintain the optimum battery charging parameters. The handpiece may therefore be placed
back into the charging unit at the end of each treatment and left there, regardless of the charge
of the battery.
5.1 New Battery - First Charging
NOTE: The battery of the starlight uno is provided partially charged.
To charge completely the battery:
1. Place the handpiece into its housing in the charging unit (Figure 6 at page 10 - Ref. B).
The yellow battery LED will light up (Table 1 at page 11 - Ref. B).
2. The charging phase has been completed when the battery LED turns to green.
5.2 Low Battery Indication
When the charge of the battery becomes low, after frequent use of starlight uno, the
microprocessor will allow 6 more exposures to be carried out (FASt or SLOW RISE) without any
need to recharge the battery.
A battery low state is signalled at the end of each of these 6 cycles by means of 2 beeps.
Once the 6 cycles have been completed, the handpiece enters a battery discharged state (see
Chapter 5.3 on page 13
Place the starlight uno handpiece back into the charging unit.
5.3 Battery Discharged Indication
the battery of starlight uno is discharged if no light is emitted when pressing the on/off button
and at the same time an acoustic signal is produced (2 beeps). Recharge the battery:
1. Place the handpiece into its housing in the charging unit (Figure 6 at page 10 - Ref. B).
The yellow battery LED will light up (Table 1 at page 11- Ref. B).
Test LED
Yellow ON
Green ON
).
Position of the
handpiece in
Function
the charging
unit
Low light
Not inserted
emission.
Light emission
suitable for
Not inserted
an effective
treatment.
BAttERY
13