Mectron starlight uno Mode D'emploi Et D'entretien page 14

starlight uno
CAUTION: In case the final user, operating in their own medical room or surgery, in order
to comply with mandatory requirements, must periodically inspect the equipment present
in the surgery, the test procedures to apply to medical electrical equipment and medical
electrical systems for the safety assessment must be carried out following the standard EN
62353 'Medical electrical equipment - Periodic inspections and tests to be carried out after
repair of medical electrical equipment'. The interval for periodic checks, in the intended
operating conditions and described in this "Use and Maintenance" manual, is one year or 2000
hours of use, depending on which of these two conditions occurs first.
WARNING: If an adverse event and/or serious incident attributable to the device occurs
during correct and intended use, it is recommended to report it to the Competent Authority
and to the manufacturer indicated on the product label.
2 IDENTIFICATION DATA
A correct description of the model and of the serial number of the device will allow the After
Sales Service to provide fast and effective answers.
Always provide this information every time that you contact MECtRON After Sales Service.
2.1 Identification Label of the Charging Unit
Each charging unit is provided with an identification label (see Figure 2 at page 6) on which
the main technical specifications and the lot number are reported. the identification label is
placed to the underside of the equipment. The complete technical data are reported in
11 on page 25
.
NOTE: The complete list of symbols is reported in Chapter 9 on page 23.
Figure 2 – Identification Label of the Charging Unit
6
starlight uno
-CHARGER-
~
100-240 V - 50/60Hz. 15 VA
000000000
YYYY - MM - DD
Data Matrix HIBC 128
manufacturer
Mectron S.p.A.
Via Loreto 15/A
16042 Carasco - GE - Italy
00000000
Rx only
Electrical Safety
ES 60601-1
made in Italy
Chapter