Publicité
Les langues disponibles
Les langues disponibles
starlight uno
4.2
Connecting the Accessories
In order to make the equipment operational it is necessary to proceed as follows:
1.
Place the charging unit on a flat surface;
2.
Plug the power cable (Figure 5 at page 8 - Ref. F) into the connector on the back side
of the charging unit (Figure 6 at page 10 - Ref. A) and then into the power outlet. the
green power LED should light up (Table 1 at page 11 - Ref. A).
3.
Connect the battery module to the handpiece by tightening the nut of the battery
module to the handpiece as shown in Figure 7 at page 10.
CAUTION: Make sure that the voltage and frequency of the power-supply line match the
values indicated on the identification label under the charging unit.
! WARNING: Check the condition of the power cable regularly. If it is found to be damaged,
replace it with an original Mectron spare part.
CAUTION: Place the device in such a way as to always have the power plug easily
accessible as it is considered to be a disconnection device.
10
A
Figure 6 – Charging unit.
Figure 7 – Battery module insertion.
B
Publicité
