Mectron starlight uno Mode D'emploi Et D'entretien page 23

CAUTION: Do not burn the battery or expose it to a high temperature. there is a risk of
explosion.
CAUTION: Do not short-circuit the battery terminals. this could cause burns and fire.
6 USE
6.1 Connecting the Accessories
! WARNING: Check the condition of the device before the treatment. Before each
treatment, always make sure that the equipment is working properly and check the efficiency
of the accessories. If any improper functioning is noted, do not proceed with the treatment. If
the problem concerns the equipment contact an authorised technical assistance centre.
! WARNING: Infections control. For maximum safety of the patient and of the operator,
before each treatment, clean and disinfect the charging unit and the handpiece, cleanse
and sterilise the optical protection and replace the protective sheath. Carefully follow the
instructions provided in
! WARNING: The protective sheaths are single use. Each protective sheath must be used for
one application only on a single patient.
Before using the starlight uno proceed as follows:
1. Ensure the battery module is correctly connected to the handpiece;
2. Insert the single use protective sheath onto the handpiece (Figure 8 at page 15 - Ref.
A);
3. Fix the optical protection onto the handpiece (Figure 8 at page 15 - Ref. B).
Chapter 7 on page 18
.
A B
Figure 8 – Connecting the Accessories
USE
15