Publicité
Les langues disponibles
Les langues disponibles
To prevent improper connections leading to damage of
electrical components and so voiding the warranty, the
following steps must be performed:
1. Check the electrical requirements and make sure you have
the correct electrical supply and that the range is properly
grounded.
2. Before the range is connected, turn on the power supply.
3. Check power at the junction box wires using a voltmeter
having a range of 0-250 VAC. If you have installed the
oven for use on 240 Volt supply, you should find that the
voltage reading between the black and red wires (Line to
Line) should be 220 to 240 Volts.
4 Connect the range to the power supply.
5. Set the clock by following these steps:
• Press
key twice until the display shows "SET TIME".
TIME
+
• Immediately press
or
• Press
TIME
key again to change minutes.
+
• Immediately press
or
change by ten (10) minutes step.
• Press
key or wait for a few seconds.
TIME
Clock is now set.
6. Test the bake mode by following this step:
• Move cooking mode knob to "BAKE" position.
• Cooling fan, oven lights, preheat led will turn on.
• A beep is sounded when the oven reaches the preset
350 °F (175 °C) and the preheat light turn off.
• Move the knob back to "OFF" position to stop cooking.
7. To check the other oven functions refer to the "Using the
Oven Controls" section.
8. If the oven is working properly, turn off the power supply to
the oven.
9. Place the cover on the junction box and make sure the cover
is securely fastened and turn on the power to the oven.
keys to set hours.
-
-
keys to set minutes, hold to
8 - Final checklist
EN
17
Publicité
