Publicité
Les langues disponibles
Les langues disponibles
31 - Element and Control Setting
EN
ELEMENT AND CONTROL SETTING
Control knobs and power level adjusting
The placement of each knob corresponds to the placement of
the induction element that it controls.
To turn on any, PUSH and TURN the knob clockwise to the
required setting, of the according cooking zone can be
increased between a minimum of 1 to a maximum of 9. To
reduce the power of the cooking zone again it is necessary to
turn the knob anticlockwise.
The current power level is displayed on the display unit of the
hob.
44
Melting function
If the knob is turned clockwise from zero position the first "power level" reached is the melting function.
The according 7 segment display unit shows this "u" symbol. The melting function is used to heat up
the bottom of the pot (40°C inside the pot). This function is used to melt food. The maximum time for
using the melting function is limited to 2 hours.
Warming function
The warming function is the second "power level" which will be selected when turning the knob
clockwise. The according 7 segment display unit shows this "U" symbol. The warming function is used
to heat up the bottom of the pot to 70°C (65°C inside the pot). Using this function the food can be kept
warm or it can be used to warm up food gently.
The maximum time for using the warming function is limited to 2 hours.
Automatic Heat Up time function
To activate the heat up time automatic press and turn the knob counterwise in overwind position "A"
until a beep sounds and the "A" symbol on the display starts blinking waiting for an input. Within the
next 10s a valid cooking level has to be selected from 1 to 8.
This will be the cooking level after a defined time of higher power output at level 9. The 7 segment
display alternates between "A" and the selected cooking level.
If the knob is turned clockwise by selecting level 0, level 9, (warming, melting) or in any position
counterwise the automatic heat up function will be turned off.
TIMER FUNCTION (FOR 36" ONLY)
Timer function setting
NOTE: the timer is only intended as an acoustic advisor that
recalls the attention of the user.
Timers have no effect on the heating elements.
Cooking zones must always be stopped manually
by rotating the knob in the corresponding [OFF]
position.
It's possible to set the timer from 1 to 9h59 minutes: it beeps
when the time has run out. This function is always available
and is indicated by the clock symbol "H" which is located in
the middle of cooktop above the power setting displays.
Timer setting
• Push the Timer knob until "H000" appears, the first two
digits H0 start to blink, turn the knob left/ right in order to
set the timer value (Hour), press the knob again to set the
minutes following the same procedure, confirm the timer
value by pressing the knob.
• Pushing the knob before the time is expired is possible
pause it (P is displayed), then restart it by pressing the knob
again.
• To delate the timer setting keep pressed the knob for about
3 second until the display value disappears.
Publicité
