COMPACT PIEZO LED
4.4
Instructions for Use
Correctly insert the scaler handpiece
onto its cord by matching the alignment
notch on the handpiece connector with
the alignment key on the cord connector.
Check that the electrical contacts of both
are perfectly dry and if necessary dry
them by blowing with compressed air;
Screw in the preselected insert on the
COMPACT PIEZO LED handpiece until it
comes into contact
Tighten the insert using the Mectron
torque wrench.
For correct use of the Mectron torque
wrench, proceed as follows:
• Place the insert inside the
MECTRON torque wrench as shown
in the figure;
14
1
2
3