Cleaning, Disinfection And Sterilization Of The X-Smart Iq; Contra-Angle - Denstply Sirona X-Smart IQ Protocole D'utilisation

Cleaning, Disinfection and Sterilization
7.5 Cleaning, Disinfection and Sterilization of the
X-Smart IQ
The X-Smart IQ
and sterilized before and after every treatment.
Always start with preparation at the point of use and manual pre-cleaning in
accordance with section 7.5.1 Pre-Treatment of the X-Smart IQ
Frequent reprocessing has minimal effects on the service life of X-Smart IQ
angles. The end of the product service life is normally dependent on wear and tear, or
damage caused by use.
Please refer to the manufacturer's information regarding equipment, cleaning agents
and rinsing agents.
Overview of X-Smart IQ
X-Smart IQ
Pre-Clean/
Method
Wipe down
Thermal
disinfection (if
applicable).
Sterilization Yes
required
following this
step
®
X-Smart IQ Contra-angle sterilization and drying time with Dynamic Air Removal Prevacuum cycle
Dynamic air
removal
Yes
(pre-vacuum)
sterilization
Dynamic air
removal (steam
flush pressure Yes
pulse)
sterilization
END-IFU-X-SMART-IQ-V16-WEB-EUR-Multilingual-2021-01
®

Contra-angle

®
Contra-angle must be pre-cleaned, thermally disinfected (if applicable)
®
Contra-angle cleaning, disinfection and sterilization
®
Contra-angle cleaning and disinfection parameters
Lubricate (for
complete
(Minimum):
instructions,
Temp / Time
see
Section 7.4)
Cleaning at
65°C (149°F) /
5 min.
After
Disinfection at
90°C (194°F) /
5 min
Sterilize at
Before 132°C (270°F) /
4 min
Sterilize at
Before 132°C (270°F) /
4 min
®
Contra-angle.
DFU Section/
Drying Time
Drying performed
automatically
For complete
during the drying
instructions, see
cycle in the
Section
washer-
disinfector
For complete
Drying time is
instructions, see
30 min
Section
For complete
Drying time is
instructions, see
30 min
Section
®
Contra-
Page
7.5.2
7.5.3
7.5.3
29/52