Lubrication Of The X-Smart Iq ® Contra-Angle - Denstply Sirona X-Smart IQ Protocole D'utilisation

Cleaning, Disinfection and Sterilization
7.4 Lubrication of the X-Smart IQ
It is essential to lubricate the X-Smart IQ
internal cleaning procedure, before every sterilization or after 30 minutes of use. It is
recommended to use W&H Service Oil F1 MD-400 Oil Spray Can, 400 ml.
• When lubricating the X-Smart IQ
X-Smart IQ
operation.
• Do not place the X-Smart IQ
ultrasonic bath.
• Wear protective gloves during preparation and transportation of the X-Smart IQ
Contra-angle.
• Use only cleaning agents that do not have protein-binding effect.
Always calibrate the X-Smart IQ
been sterilized or exchanged. The calibration function is available in the Endo IQ
Lubricate the X-Smart IQ
Use the included X-Smart IQ
angle.
Dentsply Sirona recommends reprocessing the X-Smart IQ
automatic reprocessing device, e.g. the adapter available from Dentsply Sirona.
Please perform the following steps to lubricate the X-Smart IQ
N°
A
Remove the X-Smart IQ
B
Attach the X-Smart IQ
Lubricate the X-Smart IQ
C
for Use of the oil spray can.
A
28/52
®
®
Handpiece. This could damage it and negatively impact safety during
®
Contra-angle in a disinfectant solution or in an
®
Handpiece after the X-Smart IQ
®
Contra-angle immediately after thermal disinfection.
®
Spray Nozzle to lubricate the X-Smart IQ
®
Spray Nozzle cap.
®
Spray Nozzle to the oil can (e.g. W&H Service Oil F1 MD-400).
®
contra-angle according to the information in the Instructions
B
END-IFU-X-SMART-IQ-V16-WEB-EUR-Multilingual-2021-01
®
Contra-angle
®
Contra-angle at least once a day, or after every
Contra-angle, ensure that no oil contaminates the
®
Action
C
®
Contra-angle has
®
®
Contra-
Contra-angle using a fully
®
Contra-angle:
®
App.