Adjustment Menu In Synergic Mode; Adjustment Menu In Manual Mode - GYS ARCPULL 350 Mode D'emploi

Operating manual

8.4.1. ADJUSTMENT MENU IN SYNERGIC MODE

When the machine is operating in synergic mode, the settings menu allows you to select the type of insert to be
welded, its size, its material and its type of gas protection.
In Synergic mode, the choice of settings is made in order from top to bottom:
1 - "Electrode" insert type: stud, nail, ring, etc.
2 - Size of insert "EP. elec": Mx, Øx, etc.
3 - Insert materials: Fe, FeCu, Al, etc.
4 - Type of welding protection: Ferrule, Nogaz, or with Gas
Note: When the weld must be made under gas shielding, the gas displayed is the one recommended to guarantee the
behavior of the weld (see § 5.3). If this gas is not available, it may be necessary to switch to Manual Mode (see
§ 8.2).
Setting order
Press the G and G- keys to move the cursor to the left and press the D and D- keys to modify the values of each item.
Pressing the button validates the synergy settings and returns the machine to the synergic welding screen.
Press the back button

8.4.2. ADJUSTMENT MENU IN MANUAL MODE

When the machine is operating in manual mode, the settings menu allows you to individually adjust all the parameters
taken into account in a weld.
Pressing the G and G- key highlights the selected parameter. Pressing the D and D- key changes the value of this
parameter.
1 - "Flex" digital spring:
• Releases (ON) or locks (OFF) the drive shaft of the electrode holder when the insert comes into contact with the
support plate.
• It is recommended to enable this feature for all inserts except pull rings.
Translation of the original
instructions
Réglages Synergie
> Electrode
EP. élec.
Matériau
Gaz
to ignore the settings and return to the Main Menu.
Réglages Manuel
1
2
Ressort
> Goujon
M8
FeCu
ArCo8%
> ON
3 4
ARCPULL 350
6
5
57