Gun Handling - GYS ARCPULL 350 Mode D'emploi

Operating manual
6.8. USING ARCPULL 350 DIFFICULT ACCESS SETS (070813)
Note1: Prepare the grounding rods as explained in §6.1.
Note 2: Prepare the stud holder as explained in §6.2.
Note 3: Choose the bush suitable for the material of the insert to be welded. The barrel engraved with a
suitable for welding aluminum parts.
Remove the knurled nut (n°2 - Fig 2) from
the gun drive shaft and screw the stud hol-
der support into it.
Lightly screw the protective gas nozzle onto
the stud holder support, insert the stud hol-
der into it as far as it will go and tighten the
protective gas nozzle.
Assemble the gun for laying the rod with the
shoe (pay attention to the positioning of the
holes) and mount the assembly on the rods
of the gun.
Loosen the gun knob (n°3 - Fig 2).
Adjust the barrel so that the tip of the rivet
extractor rod protrudes slightly (0.5-2mm)
and tighten the gun knob.

7. GUN HANDLING

7.1. WELDING OF PULLING RINGS
1. Mount the ring holder (see §6.3).
2. Strip the paint where the welding is to be done.
3. Select the synergy adapted to the ring to be welded.
4. Connect the negative texas of the gun to the post (no use of ground clamp).
5. In the case of operation in manual mode: set the "Flex" digital spring to OFF
(see §8.4.2).
Translation of the original
instructions
0.5 to 2mm
ARCPULL 350
is not
51