Air Pressure Adjustment - GYS NEOCUT 105 Mode D'emploi

• Automatic cutting with torch AT 125 (6 m : ref. 038479, 12 m : ref. 039520, 15 m : ref. 069787, 20 m : ref. 069794) :
• Automatic cutting with torch AT 160 (6 m : ref. 067479, 12 m : ref. 067486, 15 m : ref. 069800, 20 m : ref. 069817) :
• Gouging with torch MT 125 (6 m : ref. 039506, 12 m : ref. 039513) :
CUTTING CURRENT SETTINGS
In order to obtain the expected performance and to guarantee a long lifetime for the consumables, make sure the current is set in
accordance with the value indicated on the consumable (e.g. 45 A = 45 amps).
Adjustment is simply done using the dial on the main screen.

AIR PRESSURE ADJUSTMENT

The NEOCUT is equipped with an electronicallycontrolled pressure regulator, the pressure is adjusted via the HMI (see following pages).
In order to obtain optimal performance and service life of the consumables, it is very important :
- To define the right torch length
- To use the adapted mode for the chosen consumables
- To use the appropriate current for the chosen consumables
- Leave the pressure setting on «auto».
It is recommended to check that the parameters entered on the HMI are in line with the actual configuration, especially in the case of:
- Connection point or pneumatic installation changes
- Torch length change
- Consumable type change
- Doubt.
It is possible to check the pneumatic circuit using the «air test» function, this allows, among other things, to check whether the pressure supplied
by the compressor is sufficient (see following pages).
NEOCUT 105 / 125 EN
23