List Of Messages Displayed At The Bottom Of The Welding Screen; Main Menu - GYS ARCPULL 350 Mode D'emploi

Operating manual

8.3. LIST OF MESSAGES DISPLAYED AT THE BOTTOM OF THE WELDING SCREEN

Message
Gun disconnected
texas offline
reverse texas
Ready
Movement only
Contact
Welding
Welding completed
Pre-gas
contact lost
arc break
Raise Gun

8.4. MAIN MENU

To access the Main Menu from Synergic and Manual modes, press the button
Press the G and G- keys to move the > heading cursor. Select the item by pressing the button
• "Settings" accesses the welding parameters (synergic or manual).
• "Manual Mode" / "Synergic Mode" changes the welding mode of the station.
• "Programs" accesses user-saved weld setup save or recall functions.
• "Configuration" accesses the advanced configuration of the station (languages, gas management, information,
etc.).
Press the back button
56
Translation of the original
instructions
Description
No gun is connected to the device.
The positive texas of the gun is not connected to the generator (no.6 - Fig 2).
(Only in synergic mode). The polarity of the texas is reversed compared to that requested
by the synergy.
Once the rest cycle is complete, the product is available for welding
A trigger press has been detected without an insert having been brought into contact with
the support plate. The gun then performs a mechanical movement alone, the generator is
not started.
The product detects that an insert is in contact with the support plate. If the welding is done
under gas protection, the gas solenoid valve opens for the Pre-gas.
Welding cycle in progress.
The welding cycle is finished.
Displayed when a trigger press is detected before the Pre-gas time has elapsed (see §
8.4.4). For the weld to be made, it is necessary to remain in position (inserted part still in
contact with the support plate), and to wait for the end of the pre-gas.
Appears when contact between the insert and the support plate has been lost before the
Preflow time has elapsed.
An arc break has occurred during the weld cycle.
Welding verification is required.
Appears at the end of the weld cycle, if the gun is still in position on the insert.
Menu Principal
> Réglages
Mode Synergique
Programmes
Configuration
to return to the welding screen.
ARCPULL 350
.
.