Type Of Parts To Be Welded - GYS ARCPULL 350 Mode D'emploi

Operating manual
On the Synergic Mode main screen are displayed:
1 - The material of the insert: AlMg, Fe, etc.
2 - The type of bath protection: No Gas, Ferrule, or the type of gas recommended
3 - The pictogram of the piece to be welded
4 - The thickness of the sheet on which the part will be welded
5 - "Prog" followed by the number is displayed in the case of a saved welding configuration (see §8.4.3).
6 – A message zone specifying the state the product is in (see § 8.3)
1
FeCu
ArCo_8%
2
M8
3
8.1.1. TYPE OF PART TO BE WELDED
From the synergy displayed on the screen, defined by a type of part (3), its material (1) and its protection (2), it is pos-
sible to modify only the size of the part (M4, M5, etc.) by pressing G and G- without having to go through the settings
menu (see § 8.4.1).
Added part Pictograms
Pulling ring
Rivet Extractor
Rod
Internally
Threaded Stud
Stud (and pawn)
insulation nail
54
Translation of the original
instructions
5
Prog 3
4.0
zone de
zone de
message
message
6
Comments
Pressing G and G- cycles through all ring synergies contained in the station.
Material (1) and gas protection (2) are dynamically updated.
When a rivet extraction rod synergy is chosen, the thickness display (4)
changes automatically and corresponds to the diameter in millimeters of the
rivet head to be extracted.
Synergies associated with US type short-time internal thread studs.
The Mx value corresponds to the internal thread of the stud.
Associated synergies:
• Low carbon steel (Fe) and stainless steel: DD type threaded stud
• Copper-plated steel (FeCu): PS-type short-time threaded stud
US type short time pawn
4
ARCPULL 350