GYS ARCPULL 350 Mode D'emploi page 52

Operating manual
6. Insert a ring in the ring holder.
7. Unlock the earth clamp rods with the knob.
8. Position the gun on the sheet and bring the ring into contact with the sheet.
As soon as the gun emits a "beep" or its contact LED (blue) is lit, lock the
support rods with the knob.
9.
10. Once the weld is complete, unlock the wheel to release the rods and raise
the gun to clear the ring.
7.2. WELDING OF ADD-ON PARTS EXCLUDING PULLING RINGS
1. Mount and adjust the accessory (gas protection, ceramic adapter, rivet extrac-
tion accessory)
2. Position the earth clamps on the support plate, ensuring that there is equi-
distance between the clamps and the weld zone of the added part (see §5.7).
Grounding areas should be stripped, cleaned and free of grease.
3. Select the appropriate synergy, or, in the case of operation in manual mode:
set the "Flex" digital spring to ON (see §8.4.2).
4. Position the gun on the sheet. As soon as the gun emits a "beep" or its contact
LED (blue) is lit, press the gun so that the accessory is correctly pressed against
the sheet (there must be no rocking movement).
5.
6. When the weld is complete, raise the gun to clear the insert.
52
Translation of the original
instructions
Press the trigger while keeping the gun firmly
under pressure on the support plate.
Press the trigger while keeping the gun firmly
under pressure on the support plate.
ARCPULL 350