Declaration Of Conformity - GYS MONOMIG 160-1 Notice D'utilisation

Burns :
Fire risks :
Smokes :
Extraprecautions :
The persons carrying pacemaker have to consult a doctor before using these machines
In TIG welding, manipulate the gas bottle carefully. Indeed, there are risks if the bottle or

DECLARATION OF CONFORMITY :

The equipment described on this manual is conform to the instructions of low voltage 73/23/EEC of 19TH
February 1973 (amended by 93/68/EEC), and the instructions of CEM/89/336/EEC of the 3rd of May 1989,
(amended by 92/31/EEC, 93/68/EEC, 91/263/EEC).
This conformity respects the standards EN50199 of 1995 (CEM instruction), EN 60974-1 of 1998, and
amendments A1 of 2000 and A2 of 2003.
CE marking was added in 2004.
01/07/06
Société GYS
134 BD des Loges
53941 Saint Berthevin
MONOMIG 160-1
Wear protective or fire-proof clothing (overalls, jeans).
Use some welder gloves and a fire-proof apron.
Protect the others by installing non flammable protection wall , or prevent the
others to not look at the arc and to keep a sufficient distance
Suppress all flammable products from the working area. Do not works near
flammable gas.
Do not inhale gas or welding smokes. If indoors ventilate the area well and/or
use local extraction ventilation equipment to remove fumes and gases.
Any welding operation :
- in environments with increased risk of electric shock,
- in confined spaces,
- in the presence of flammable or explosive materials
must be evaluated in advance by an "Expert supervisor" and must always be
carried out in the presence of other people trained to intervene in case of
emergency.
Technical protection measures MUST BE taken as described in the TECHNICAL
SPECIFICATION "IEC 62081".
Welding in raised positions is forbidden unless safety platforms are used.
Do not use the unit to thaw tubing.
the bottle valve are damaged.
Nicolas BOUYGUES
Président Directeur Général
7/12