Yamaha AW1600 Mode D'emploi page 217

5.5. MIDI TIME CODE QUARTER FRAME (F1)
< Transmission >
If [MIDI OUT] is set to MTC, Quarter Frame messages will be trans-
mitted according to the time code movements of the recorder when
the recorder is playing or recording.
< Reception >
This message is received if [MTC SYNC MODE] is set to SLAVE.
Quarter Frame messages received in realtime are internally assem-
bled into time code that controls the recorder.
Quarter Frame Message
STATUS 11110001 F1
nnn = message type (0-7) dddd = data
DATA 0nnndddd dd
5.6. SONG POSITION POINTER (F2)
< Transmission >
If [MIDI OUT] is set to CLK, a song position message will be trans-
mitted when STOP or LOCATE is performed on the recorder, to indi-
cate the song position from which the song should start at the next
START or CONTINUE message.
Song Position Pointer
STATUS 11110010 F2
data ( H) high 7 bits of 14 bits data
DATA 0ddddddd dd0
data ( L) low 7 bits of 14 bits data
0ddddddd dd1
5.7. TIMING CLOCK (F8)
< Transmission >
If [MIDI CLK] is ON, this message is transmitted according to the
MIDI Tempo Map from when the recorder begins playing or record-
ing, until it stops.
Timing Clock
STATUS 11111000 F8
5.8. START (FA)
< Transmission >
If [MIDI CLK] is ON, this message is transmitted when the recorder
begins playing or recording at a location other than the first measure.
Start
STATUS 11111010 FA
5.9. CONTINUE (FB)
< Transmission >
If [MIDI CLK] is ON, this message is transmitted when the recorder
begins playing or recording at a location other than the first measure.
STATUS 11111011 FB Continue
5.10. STOP (FC)
< Transmission >
If [MIDI CLK] is ON, this message is transmitted when the recorder
stops.
Stop
STATUS 11111100 FC
5.11. ACTIVE SENSING (FE)
< Reception >
Once this message is received, subsequent failure to receive any mes-
sage for a period of 300 ms will cause Running Status to be cleared,
and MIDI communications to be initialized.
Active Sensing
STATUS 11111110 FE
5.12. RESET (FF)
< Reception >
When a Reset message is received, MIDI communications will be
initialized by clearing Running Status etc.
Reset
STATUS 11111111 FF
5.13. EXCLUSIVE MESSAGE (F0-F7)
5.13.1. MMC
5.13.1.1. MMC STOP
< Transmission >
When the STOP key is pressed, this message is transmitted with a
device number of 7F.
< Reception >
If the AW1600 is operating as an MMC Slave, the transport will stop
when this message is received with a matching device number or a
device number of 7F.
System Exclusive Message
STATUS 11110000 F0
Real Time System Exclusive
ID No. 01111111 7F
Destination (00-7E, 7F:all call)
Device ID 0ddddddd dd
Machine Control Command (mcc) sub-id
Command 00000110 06
Stop (MCS)
00000001 01
End Of Exclusive
EOX 11110111 F7
5.13.1.2. MMC PLAY
< Reception >
If the AW1600 is operating as an MMC Slave, the transport will
begin playback when this message is received with a matching device
number or a device number of 7F.
System Exclusive Message
STATUS 11110000 F0
Real Time System Exclusive
ID No. 01111111 7F
Destination (00-7E, 7F:all call)
Device ID 0ddddddd dd
Machine Control Command (mcc) sub-id
Command 00000110 06
Play (MCS)
00000010 02
End Of Exclusive
EOX 11110111 F7
5.13.1.3. MMC DEFERRED PLAY
< Transmission >
This message is transmitted with a device number of 7F when the
PLAY key is pressed.
< Reception >
If the AW1600 is operating as an MMC Slave, the transport will
begin playback when this message is received with a matching device
number or a device number of 7F.
System Exclusive Message
STATUS 11110000 F0
Real Time System Exclusive
ID No. 01111111 7F
Destination (00-7E, 7F:all call)
Device ID 0ddddddd dd
Machine Control Command (mcc) sub-id
Command 00000110 06
Deferred play (MCS)
00000011 03
End Of Exclusive
EOX 11110111 F7
5.13.1.4. MMC FAST FORWARD
< Transmission >
This message is transmitted with a device number of 7F when the FF
key is pressed.
< Reception >
If the AW1600 is operating as an MMC Slave, the transport will
begin fast-forward when this message is received with a matching
device number or a device number of 7F.
System Exclusive Message
STATUS 11110000 F0
Real Time System Exclusive
ID No. 01111111 7F
Destination (00-7E, 7F:all call)
Device ID 0ddddddd dd
Machine Control Command (mcc) sub-id
Command 00000110 06
Fast Forward (MCS)
00000110 04
End Of Exclusive
EOX 11110111 F7
Mode d'emploi de l'AW1600
Format des données MIDI
217