Cleaning And Maintenance - Franke FSM 97 P Mode D'emploi

CLEANING AND MAINTENANCE

Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth�
If they are very dirty, add a few drops of pH-neutral
detergent� Finish off with a dry cloth�
• Do not use corrosive or abrasive detergents� If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth�
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues� To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
REPLACING THE LAMP
1.
Disconnect the oven from the power supply�
2.
� Remove the cover from the light, replace the bulb
and put the cover back on the light�
3.
Reconnect the oven to the power supply�
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position�
2.
Close the door as much as you can�
Take a firm hold of the door with both hands – do not
hold it by the handle�
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b)�
~60°
Put the door to one side, resting it on a soft surface�
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
oven to cool completely and then wipe it with a cloth
or sponge�
• If there is stubborn dirt on the interior surfaces, we
recommend running the automatic cleaning function
for optimal cleaning results�
• Clean the glass in the door with a suitable liquid
detergent�
• The door can be easily removed and refitted to
facilitate cleaning of the glass�
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot� Food residues can be removed using a
washing-up brush or a sponge�
Please note: Only use 25-40W/230V type E-14, T300°C
incandescent lamps, or 20-40W/230 V type G9, T300°C
halogen lamps. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating�
4.
Lower the door and then open it fully�
Lower the catches into their original position: Make
sure that you lower them down completely�
5.
Try closing the door and check to make sure that it
lines up with the control panel� If it does not, repeat
the steps above�
PRESS TO CLEAN - CLEANING THE GLASS
1.
After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you�
~15°
b
a
2.
Firmly hold the panes of glass with both hands,
remove them and place them on a soft surface before
cleaning�
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
EN
11