All-Refrigerator And All-Freezer; The Installation Space; Dimensions And Clearances - Monogram ZKFN Instructions D'installation

Design Guide - Flush Inset Installation for

THE INSTALLATION SPACE

4-5/16"
9"
26-3/16" Minimum
85"
Finished
Opening
3-1/2"
7"
3-1/2"
Water And Electrical Locations
Electrical and water supply must be located as shown.
Cutout Depth Beneath a Soffit:
When installed beneath a soffit, the soffit cannot
exceed the 26-3/16" (66.52 cm) installation depth
shown.
The Cutout Depth Must Be 26-3/16" (66.52 cm)
Wooden cleats are required for flush installation. See
Side Cleats on page 48.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter the opening through the floor or
back wall. The water line should be 1/4" O.D. copper
tubing or QuickConnect
line and water connection location, long enough
to extend to the front of the unit. Installation of an
easily accessible shut-off valve in the water line is
required.
31-1000454 Rev. 0

All-Refrigerator and All-Freezer

39"
Finished Width
Wall View
5-1/2"
Electrical
Area
Cutout Depth
75-1/2" From
Cold Water
Floor to Bottom
Supply
of Electrical Area
3-1/2"
7"
3-1/2"
3-1/2"
kit between the cold water
™

DIMENSIONS AND CLEARANCES

35"
Case Width
*83-1/2"
at
Rear
Depth Including
3/4" Panels 25-15/16"
Product Clearances
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted
to 90° if clearance to adjacent cabinets or walls is
restricted.
90° Door Swing
4" Minimum
to a Wall
90° Door Swing
23-7/8"
Case Behind
Frame
38-3/4"
90°
For a 90° door swing, allow 4-5/8" (10.16 cm)
minimum clearance to a wall for framed and stainless
steel models. If the 90° doorstop position is used, pan
access is maintained but pan removal is restricted.
41
* Shipping height. The
product can be adjusted
to fit into a cutout that
is 85" (215.9 cm) max.
*84" From
Floor to
height. Use leveling
Top Frame
legs and wheels for a
maximum 1" (2.54 cm)
height adjustment.
38-3/4" Frame to
Frame Width
115° Door Swing
115°
15"
Min. to
Wall