Step 10 Install Grille Panel; Step 11 Install Assembled Panels; Freezer Drawer - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
French Door Bottom Freezer Refrigerator

STEP 10 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel and into the
trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.

STEP 11 INSTALL ASSEMBLED PANELS

• Install custom handles according to the manufacturer's
instructions.
FRESH FOOD DOORS
• Beginning with the right fresh food door, slide
assembled door panel into the trim on the door.
• Place the custom handle trim against the side of the
refrigerator door, aligned top to bottom. The holes in the
trim should align to the holes in the door.
Flange Trim Cover
and 4 Screws
Double-Sided
Mylar Tape
Located
on Back of
Flange Trim
Cover
Door
Handle
Flange
Trim
Trim
Cover
2-sided
Mylar
Tape
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
• Attach the custom handle trim with the 8 screws
• Repeat these steps with the left fresh food door.

FREEZER DRAWER

• Slide the assembled panel into the drawer trim.
• Secure the original drawer trim using the original round
Custom Handle
Shims
Trim and 4 Screws
Shims
20
weight, if necessary.
previously removed.
head trim screws.
Door Trim and
8 Screws
31-1000454 Rev. 0