Step 13. Connect Power; Step 14 Start Icemaker - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
STEP 12 CONNECT WATER SUPPLY
(Cont.)
SmartConnect ™ Tubing:
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
SmartConnect ™ Refrigerator Tubing Kits are available
in the following lengths:
2' (.6 m) WX08X10002
8' (2.4 m) WX08X10006
15' (4.6 m) WX08X10015
25' (7.6 m) WX08X10025
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
• Run dispenser, if applicable, for 2 minutes.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
STEP 13 CONNECT POWER, CLOSE
GRILLE PANEL
• Open the grille panel.
• Plug in the power cord (if necessary) by reaching
into the opening next to the water filter. The water
filter guard will need to be removed for access (some
models). Remove the 3 screws holding it in place. If
access is still too tight, remove the 2 screws holding
the water filter bracket and move aside. Plug in the
power cord. Secure the bracket and guard with the
original screws.
Screws
Bracket
Screws
Guard in Front of
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are on.
• The temperature controls are preset at 37°F (3°C) for
the fresh food section and 0°F (-18°C) for the freezer.
• Allow 24 hours to stabilize before making adjustments.
Side-by-Side Refrigerator
™ Refrigerator Tubing kits.
Water Filter
Electric Outlet
Access

STEP 14 START ICEMAKER

CAUTION
Avoid contact with the moving parts
of the ejector mechanism, or with the heating element
(located on the bottom of the icemaker) that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the refrigerator
is plugged in.
ATTENTION
Évitez tout contact avec les pièces
mobiles du mécanisme d'éjection ou l'élément chauffant (situé
dans le bas de la machine à glaçons) qui libère les cubes.
Ne placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque le réfrigérateur est
branché dans la prise électrique.
PRECAUCIÓN
movimiento del mecanismo expulsor o con el elemento de
calefacción (ubicado en la parte inferior de la máquina de
hielo) que expulsa los cubos. No coloque los dedos ni las
manos en el mecanismo de la máquina de hielo automática
mientras el freezer se encuentre enchufado.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the ice maker OFF, see Standard Installation.
74
Evite el contacto con las partes en
Icemaker
Feeler Arm
31-1000454 Rev. 0