Step 6 Level Unit - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
STEP 5 INSTALL ANTI-TIP BRACKET (cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grille forward, down and out to
remove.
Screws
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
• Pull the bottom of the grille forward, down and out to
remove.
Screws

STEP 6 LEVEL UNIT

All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
• To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to raise
or counterclockwise to lower the unit.
• For front leveling, use a 1-1/4" open-end wrench.
All-Refrigerator and All-Freezer
Screws
Screws
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has "L" bolts in the upper left and right corners
inside of the access compartment. These bolts will
interlock with the wall bracket and secure the unit
using the washers and hair pin cotters in the hardware
kit once the unit has been leveled and is in the final
position.
• Adjust height of unit to match installation cutout opening
84-1/2" (214.63 cm). The unit should be level and
plumb with cabinetry.
NOTE: Raise appliance until the case top comes in
contact with the 1" (2.54 cm) spacer block mounted to
the underside of the cabinet soffit. Appliance should be
level at fully raised position.
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1".(2.54 cm).
If the installation requires more than 84-1/2" (214.63 cm)
height, the installer should elevate the unit on a sheet of
plywood or runners. Cabinetry trim could also be added
across the top of the opening to shorten the opening. If
you attempt to raise the unit more than 1" (2.54 cm), you
will damage the front leveling legs and the rear leveling
wheels.
54
31-1000454 Rev. 0