Step 8 Alternate Anti-Tip Procedure; Step 9 Adjust Door Swing - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
French Door Bottom Freezer Refrigerator
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
If the anti-tip bracket cannot be used, this alternate
procedure may be used to secure the refrigerator
against tip-over
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.

STEP 9 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to
a 90° opening. A 130° door swing is available for
standard installation only. If used for flush installation,
damage will occur to wood panels. Skip this step if
door opening is satisfactory for your installation
situation.
31-1000454 Rev. 0
STEP 9 ADJUST DOOR SWING
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 130° position.
Wire Cover
Trim Screws
Pin Location for
90° Door Swing
• Reinstall the wire cover trim.
WARNING
d
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
AVERTISSEMENT
de doigts
Une installation incorrecte peut poser un risque de
coincement de doigts entre la garniture de porte latérale
et les armoires en actionnant la porte, en particulier pour
les enfants. Pour réduire ce risque, vous devez suivre les
instructions d'installation relatives aux dimensions d'armoire,
au montage des garnitures et à l'angle de l'arrêt de porte.
ADVERTENCIA
el Marco de la Puerta : Una instalación inadecuada podrá
conducir a riesgos de pellizcos de dedos entre el marco lateral
de la puerta y los gabinetes al utilizar la puerta, especialmente
con los niños. A fin de minimizar este riesgo, usted deberá
seguir las instrucciones de instalación para dimensiones de
gabinetes, ensambles de marcos y ángulos de detención de
puertas.
19
Remove
Pin Location for
130° Door Swing -
Not for use with
Flush Installation
Pin Location
as Shipped for
115°
Door Swing
Door Trim Pinch Point Hazard
Risque de pincement
d
Riesgo de Lastimadura con
d