Step 11. Connect Water Supply (Freezer Models Only); Step 12 Connect Power; Step 13. Start Icemaker(Freezer Models Only) - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
STEP 11 CONNECT WATER SUPPLY
(FREEZER MODELS ONLY)
Connect to potable water supply
WARNING
only.
AVERTISSEMENT
alimentation d'eau potable seulement.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente.
House
Water Supply
• Locate and bring the tubing to the front of the cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
SmartConnect Tubing:
™
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
• Insert the molded end of the tubing into the appliance
or freezer connection. Tighten the compression nut
until it is just hand-tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
31-1000454 Rev. 0
All-Refrigerator and All-Freezer
Raccordez l'appareil à une
Freezer
Water Supply
™ Refrigerator Tubing kits.

STEP 12 CONNECT POWER

• Check to be sure the power cord is plugged into the
receptacle.
Electrical Outlet
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
• The temperature controls are preset at 37°F
(-13.89°C) for the fresh food section and 0°F
(-17.78°C) for the freezer.
• Allow 24 hours to stabilize before making
adjustments.
STEP 13 START ICEMAKER
(FREEZER MODELS ONLY)
CAUTION
Avoid contact with the moving parts of
the ejector mechanism, or with the heating element
(located on the bottom of the icemaker) that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the freezer is
plugged in.
ATTENTION
Évitez tout contact avec les pièces
mobiles du mécanisme d'éjection, ou l'élément chauffant
(situé dans le bas de la machine à glaçons) qui libère les
glaçons. Ne placez pas les doigts ou les mains sur le
mécanisme de production de glace automatique lorsque le
congélateur est branché dans la prise électrique.
PRECAUCIÓN
movimiento del mecanismo expulsor o con el elemento de
calefacción (ubicado en la parte inferior de la máquina de
hielos) que expulsa los cubos. No coloque los dedos ni las
manos en el mecanismo de la máquina de hielos automática
mientras el freezer se encuentre enchufado.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, see Standard Installation
57
Evite el contacto con las partes en
Icemaker
Feeler Arm