Step 15 Install Toekick; Inspect Final Installation - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
French Door Bottom Freezer Refrigerator

STEP 15 INSTALL TOEKICK

• Flush Installation toekicks are provided in Kit ZKFN.
• Locate inner and outer toekicks as indicated below.
Recycle all other toekicks.
• Attach the toekick assembly to the refrigerator using
the supplied screws (2).
• A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template to cut the shape.
GG
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but
can NOT cover the horizontal vent slots of the factory
toekick.
F
22

INSPECT FINAL INSTALLATION

Check Door Alignment
Stand back away from the refrigerator to inspect the
final installation.
• Installation or the addition of heavy door panels
may have caused the doors to move slightly out of
alignment. Check to be sure the top of the doors
are evenly aligned with each other. If necessary, the
doors may be adjusted up or down to align.
• Add or subtract shims as shown to adjust the right
door only. More shims are located under the hood on
the left side in the bag with the filter bypass plug and
mini manual.
To Raise Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Snap a shim onto the hinge pin below the bushing.
• Lower the door and re-check the alignment.
• Repeat as necessary.
To Lower Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Remove a shim by pushing shim off of the hinge pin.
• Lower the door and re-check the alignment.
• Repeat as necessary.
Bag location
Shim
31-1000454 Rev. 0