Step 9 Install Grille Panel; Step 10 Install Overlay Panels - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for
STEP 8 ADJUST DOOR SWING
(Cont.)
ADVERTENCIA
d
con el Borde de la Puerta
Una instalación inadecuada puede conducir a riesgos de
pellizcos de dedos entre el borde lateral de la puerta y los
gabinetes al utilizar la puerta, especialmente con los niños.
A fin de minimizar este riesgo, usted deberá seguir las
instrucciones de instalación para dimensiones de gabinetes,
ensambles de bordes y esquinas de detención de puertas.

STEP 9 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
All-Refrigerator and All-Freezer
Riesgo de Lastimadura
STEP 10 INSTALL OVERLAY
PANELS
Install door panels:
• Open door to 90°.
• Remove the 12 screws holding the trim, then lift off
the trim. Retain the screws.
Custom Handles
• Custom handles must be used for flush
installation. The handle must be properly secured
to the overlay panel before sliding the panel into
the trim.
• The cabinet
manufacturer
will supply the
custom handle and
hardware.
• Slide assembled door
panel into the trim.
• Reinstall trim by
securing with all 12
screws retained in
previous steps.
56
31-1000454 Rev. 0