Step 6 Level Refrigerator; Step 7 Alternate Anti-Tip Procedure - Monogram ZKFN Instructions D'installation

Installation Instructions - Flush Inset Installation for

STEP 6 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16" hex
nut located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the refrigerator.
• For front leveling, use a 1-1/4" (3.175 cm) open-end
wrench.
• Adjust height of
refrigerator to match
installation cutout
opening 83-1/2"
(212.09 cm) to
84-1/2" (214.63 cm).
The refrigerator
should be level and
plumb with cabinetry.
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" (214.63 cm)
height, the installer should elevate the refrigerator on a
sheet of plywood or runners. Cabinetry trim could also
be added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator more
than 1" (2.54 cm), you will damage the front leveling
legs and the rear leveling wheels.
Bottom Freezer Refrigerator
STEP 7 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping. If the anti-tip bracket cannot be used, this
alternate method can be used to prevent the unit
from tipping.
Install four 1-1/2" drywall screws through
trim and into soffit or 3/4" min. wood brace
• Raise the grille panel to access case trim.
• Use a 3/16" (0.47 cm) bit to drill four evenly spaced
clearance holes through the metal top case trim.
Drive screws through case
trim into adjacent cabinets
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.
36
Top Case Trim
Side View Top
Case Trim
Raise grille panel to
stop position
3/4" Min.
31-1000454 Rev. 0