CONTENTS
Tools, Hardware ....................................................... 3
Parts Required .......................................................... 3
ZIDI240 MODEL ONLY
PARTS REQUIRED
• Custom handles
• Overlay panels
• Spacer panels
• Backer panels
• Screws
TOOLS REQUIRED
• Adjustable wrench
• Carpenter's glue (ZIDI240 model only)
• Screwdriver (ZIDI240 model only)
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install dual-drawer
refrigerator. Failure to do so can result in back or other
injury.
WARNING
CUT HAZARD
Cabinet edges along stamp/cut-out areas may
be sharp. Avoid placing hands, fingers, or other
appendages near these areas. Failure to do so can
result in cuts.
1" = 2.5 cm; 1' = 0.3 m
31-51545-6
Important Information
PARTS SUPPLIED
• Drawer side trims
• Optional black or
stainless steel toekick
Step 3, Level ............................................................. 8
IMPORTANT: Handle with care when moving
dual-drawer refrigerator to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.
IMPORTANT: When moving the dual-drawer refrigerator,
never tilt it more than a 45° angle. This could damage
the compressor and the sealed system. If the
dual-drawer refrigerator has been placed in a horizontal
position for any period of time, wait one hour before
plugging in the refrigerator to allow the refrigerant to
settle.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (12.7°C) because it will not run
often enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not
perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
3