Monogram ZKFN Instructions D'installation page 35

Installation Instructions - Flush Inset Installation for
STEP 5 ANTI-TIP PROCEDURE (Cont.)
Install Screws and Bolts:
• Have someone hold the wall bracket centered in place
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
Lag Screw
Anti-Tip Wall Bracket
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
Bolt
Anti-Tip Wall Bracket
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
from the grill on the left.
• Pull the bottom of each grille forward, down and out to
remove.
Remove grille screws
31-1000454 Rev. 0
Bottom Freezer Refrigerator
Wood Stud
Drywall or
Steel Stud
Wall Toggle
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
from the grill on the left.
• Pull the bottom of each grille forward, down and out to
remove.
Remove grille screws
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has "L" bolts in the upper left and right corners
inside of the access compartment. These bolts will
interlock with the wall bracket and secure the unit
using the washers and hair pin cotters in the hardware
kit once the unit has been leveled and is in the final
position.
35