Customization Basics; Side Panels; Refrigerator Location; Optional Accessory Kits - Monogram ZISS480NNSS Instructions D'installation

Design Guide - Standard Installation

CUSTOMIZATION BASICS:

These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille
panels are required.

SIDE PANELS

Side panels must be
used whenever the sides
of the refrigerator will be
exposed. The 1/4"
(0.63 cm) side panels
will slip into the side
case trim. Secure the
panels to the refrigerator
with stick-on hook and
loop fastener strips.
Order the side panels
from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
31-1000450 Rev. 1
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
* Depending on installation height.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures
will go above 100°F (37°C). It will not perform
properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded (approximately 1500 pounds)..

OPTIONAL ACCESSORY KITS

ZKLN: Visor handle kit for use on custom panel
models in a standard installation.
9