Side Cleats; Refrigerator Location - Monogram ZKFN Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions - Flush Inset Installation for

SIDE CLEATS

Wood cleats are required to be installed vertically down
both sides of the cabinet opening to provide depth stop
for the refrigerator when installed into the opening.
The cleat should be installed per the diagrams below
based on the type of panel being used.
TOP VIEW
Finished
Cleat
5-1/4"
3/4" Panel
TOP VIEW
Finished
Cleat
5-3/8"
1/2" Panel
31-1000454 Rev. 0
All-Refrigerator and All-Freezer
DOOR
1/2"
Case Trim
DOOR
1/2"
Case Trim

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
49

Publicité

Table des Matières
loading

Table des Matières