Design Guide - Flush Inset Installation for
3/4" (1.9 cm) DECORATIVE PANEL
DIMENSIONS
For a more custom appearance, overlay panels may be
installed to give a flush appearance with surrounding
cabinets. The overlay panel must be 3/4" (1.9 cm)
thick. Panel attaches to
included brackets to provide
mounting to the appliance
door.
NOTE: We recommend that
decorative panels have inside
corners and edges rounded
or beveled by cabinet maker
to avoid sharp edges on the
panels. Edges to be treated
should include the top, bottom
and hinge side edges.
IMPORTANT NOTE: Maximum
total weight for the assembled
panels:
• Door panel – 67 lbs. (30.39 kg)
• Grille Panel – 18 lbs. (8.16 kg)
WARNING
Door Trim Pinch Point Hazard
d
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
AVERTISSEMENT
d
de doigts
Une installation incorrecte peut poser un risque de
coincement de doigts entre la garniture de porte latérale
et les armoires en actionnant la porte, en particulier pour
les enfants. Pour réduire ce risque, vous devez suivre les
instructions d'installation relatives aux dimensions d'armoire,
au montage des garnitures et à l'angle de l'arrêt de porte.
ADVERTENCIA
d
con el Marco de la Puerta
Una instalación inadecuada podrá conducir a riesgos de
pellizcos de dedos entre el marco lateral de la puerta y los
gabinetes al utilizar la puerta, especialmente con los niños.
A fin de minimizar este riesgo, usted deberá seguir las
instrucciones de instalación para dimensiones de gabinetes,
ensambles de marcos y ángulos de detención de puertas.
Bottom Freezer Refrigerator
38"
10-11/16"
Grille Panel
Fresh Food
Panel
46-9/16"
Freezer Drawer
22-7/16"
Panel
Risque de pincement
Riesgo de Lastimadura
CUSTOMIZATION BASICS:
Framed Or Overlay Panels, Custom
Handles and Accessory Kits
These refrigerators are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
26
31-1000454 Rev. 0