Customization Basics; Custom Handle Design Guide; Refrigerator Location; Side Panels - Monogram ZKFN Instructions D'installation

Design Guide - Flush Inset Installation for

CUSTOMIZATION BASICS:

These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille
panels are required.

CUSTOM HANDLE DESIGN GUIDE

Custom handles must be used for flush installation. For custom handle installation,
counterbore holes in rear of decorative panels must ensure 1/2" (1.27 cm) material
thickness remains for handle support.
NOTE: The counterbore must not exceed 1" (2.54 cm)in diameter.
Minimum distance from handle side edge to handle center should be 1-1/4" (3.18 cm) as
shown.
1/2"
1/4"
3/4"

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
31-1000454 Rev. 0
Side-by-Side Refrigerator
7/8"
61
0.85"
1/2"

SIDE PANELS

Side panels must be used
whenever the sides of
the refrigerator will be
exposed. The 1/4"
(0.63 cm) side panels will
slip into the side case
trim. Secure the panels
to the refrigerator with
stick-on hook and loop
fastener strips. Order
the side panels from the
cabinet manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
1-1/4" 1-1/4"
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
* Depending on installation height.